Technical parameter: 

The frame area is protected by a safety net with a mesh diameter of 35mm to 40mm, high strength polyester thread, including a top net.

Installation standards:

1.pulling the net: use safety nets to seal the top and sides, the vertical pressing deformation of the side nets shall not exceed 150mm.

2.Tie rope: horizontal and vertical pipes are stretched as shown in Figure 1. Single hole mesh ropes are used to tie and fix the steel pipes.

3.Cotton-covered pipe: cut the sponge pipe in the center, cover it on the galvanized pipe, tie it with plastic ties and tighten it

4.Cable ties: the cable ties should be tied at a distance about 300mm, should be facing upwards.